
6 Operator Maintenance
Figure 6.26: Page Entry Receiver Sensors
Figure 6.27: Page Exit Receiver Sensors
6. Close the scanner transport cover.
7. Power on the scanner.
8. Boot up the host PC.
6.4.8 Cleaning the ADF Sensor
The ADF sensor detects paper in the ADF. Dust and small particles of paper may build
up on the sensor, causing the ADF not to lower after the last page is fed. Cleaning the
ADF sensor once per week (or as needed) will reduce this problem.
To clean the ADF sensor, follow the procedure below:
1. Remove all paper from the ADF.
2. Using the sensor and transport cleaner, spray a short burst of air onto the sensor.
S006555 Rev D 79 of 113
Kommentare zu diesen Handbüchern