Kodak Document Scanner 9500 with/without Image Manager 9500 Bedienungsanleitung Seite 4
- Seite / 101
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
A-61124 March 1999 2-1
2 Scanning Concepts
This chapter provides an overview of the scanning process , a
discussion of error conditions, and two methods of fault recovery.
Scanning documents
Follow this sequence to scan documents : set up the scanner,
enable scanning, initiate polling, feed documents, and disable
scanning.
Setup
To set up the scanner:
1. Determine and select the mode (configuration) to be used for
the current application.
The mode may be selected by the host computer using a
scanner-unique command (HA), or by the operator using the
scanner control panel.
2. Determine if any changes to the Image Processing parameters
need to be made for the current application. Execute the
required scanner-unique command(s) to make the desired
changes.
Image Processing parameter changes remain in effect until
one of the following conditions occur:
— The scanner is powered down using the main power
switch.
— A SCSI bus device Reset command is executed.
— A single parameter change is overridden by another
change to the same parameter.
3. Set the Sequential ID Number Seed and/or the Next Image
Address using a scanner-unique command (DC and HC,
respectively), if desired.
4. Calibrate the scanner. For procedures on how to do this, see
the
Kodak Digital Science
Scanner 9500, User’s Guide.
5. Prepare documents according to the instructions found in the
Kodak Digital Science
Scanner 9500, User’s Guide
.
- Integrator’s 1
- 1 Introduction 2
- About this guide 3
- 2 Scanning Concepts 4
- Error handling 5
- A-61124 March 1999 2-3 6
- Fault recovery 7
- 3 Image Headers 8
- Image Addresses 9
- Assigning 9
- A-61124 March 1999 3-3 10
- Image header format 11
- A-61124 March 1999 3-5 12
- Default Image Header Format 13
- Retrieving images and 14
- Recommended retrieval 15
- Host to scanner 16
- Scanner to host 16
- SCSI data rates 16
- 5 The SCSI Interface 17
- SCSI interface signal 18
- Issuing SCSI 18
- A-61124 March 1999 5-3 19
- SCSI status responses 20
- SCSI message responses 21
- SCSI conformance 22
- SCSI commands 23
- Command block descriptor 24
- A-61124 March 1999 5-9 25
- Define Window Parameters data 26
- Get Window command 28
- Get Window descriptor bytes 30
- Get Window Parameters data 31
- Inquiry command 33
- Inquiry data 34
- Read command 35
- Release Unit command 36
- Request Sense command 37
- Request Sense data 38
- A-61124 March 1999 5-23 39
- Reserve Unit command 40
- Scan command 40
- Send command 41
- Using the Send 42
- Test Unit Ready command 43
- 6 Scanner-unique Commands 44
- Command summary 45
- A-61124 March 1999 6-3 46
- Commands 47
- BX/Y/Z — Scan resolution 48
- CX — Clear buffers 48
- DC — Sequential ID 48
- DX — No scan 49
- EX — Bit order 49
- FX/Y/Z — Compression 50
- GC — Last image 50
- GX — End of job 51
- HA — Set mode 51
- HC — Next image address 51
- JA — Define mode 52
- JX/Y/Z — Scan threshold 53
- KX/Y/Z — Scan contrast 54
- LX/Y/Z — Dither pattern 54
- (screen) 54
- MC — Count Only mode 54
- MX/Y/Z — Image 55
- NF — Level of next 55
- NX/Y/Z — Noise filter 55
- SX/Y/Z — Reverse image 56
- TX — Simplex/duplex 56
- YX/Y/Z — Border 57
- Reduction 57
- WX/Y/Z — Skew 57
- Correction 57
- Scanner-unique 58
- Recommended usage of 61
- Protocol 62
- Sample interfaces 62
- Appendix A Glossary 63
- A-2 A-61124 March 1999 64
- Kodak Digital Science 65
- A-4 A-61124 March 1999 66
- Ordering publications 67
- A-61124 March 1999 C-1 68
- C-2 A-61124 March 1999 69
- Image processing 70
- D-2 A-61124 March 1999 71
- Table D-2 — Scanner 9500 72
- Appendix E Image Processing 74
- Auto-cropping 75
- Scanner-unique Commands 77
- , Scanner-unique Commands 78
- Noise filter 80
- Resolution 82
- Screening/Dithering 83
- Adaptive Threshold 86
- Processor (ATP) accessory 86
- Image Manager capabilities 89
- Example 1 91
- Example 2 91
- 12 “ - Full width of Scanner 92
- Border reduction 93
- Skewed Document 93
- Scanned images 94
- Printed Images 94
- Computer-generated images 95
- Photographic images 95
- Evaluation criteria 96
- Staircasing 97
- Aliasing 97
- Image resolution 98
- Noise and dynamic range 99
- Brightness 100
- DOCUMENT 101
Verwandte Produkte und Handbücher für Adapter für die Scannertransparenz Kodak Document Scanner 9500 with/without Image Manager 9500
(2 Seiten)Panasonic CSE12LKEW manuali
Manuali dei proprietari e guide per l'utente per Lettori DVD Panasonic CSE12LKEW.
We fornisce manuali pdf Panasonic CSE12LKEW per scaricare gratuitamente in base al tipo di documento:
Kommentare zu diesen Handbüchern