Kodak Digital Science 8650 Bedienungsanleitung PDF herunterladen (Seite 22)

Setting up the printer

October 1997 2-7

4. To clean the print head, ﬁrst use the water pad and then use the

alcohol pad. With each pad, wipe along the heater line four times as

follows:

—Wipe the full length of the glass area (always in one direction).

—Use a clean part of the pad for each wipe.

—Apply ﬁrm, even pressure.

—Wipe the metal roller bar and rod as shown.

5. Allow the glass area to dry for about two minutes.

6. Do one of the following:

If reloading the ribbon

, load the supply spool ﬁrst (with the bar code

on the left. If the ribbon gets dirty or is damaged, wind the take-up

spool ahead to the next clean magenta section.

If loading a new ribbon

, refer to the instructions on the ribbon

package.

7. Close the printer cover, and turn the printer

AVOID METAL

EDGE!

Metal roller bar

Metal bar

Rod

Header line

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 109 110

Keine Kommentare

Kodak Digital Science 8650 Bedienungsanleitung Seite 22