Kodak Digital Science 5500 Bedienungsanleitung Seite 11
- Seite / 125
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
A-61070 September 1999 2-1
2 Getting Started
The following steps are necessary to prepare the scanner for operation.
Procedures on how to perform these steps are described in this
chapter.
1. Turn on the power to the scanner.
2. Select the language display.
3. Calibrate the scanner.
4. Prepare the documents for scanning.
5. Adjust the feed and separator roller gap, if required (semi-automatic
feeder).
6. Adjust the feed shelf position.
7. Adjust the feed shelf side guides.
8. Adjust the exit hopper side guides and end stop.
9. Select the desired application mode and image level, or the Count
Only function.
10. Start the scanner from the host computer. (This step is not
necessary for the Count Only function.)
11. Press Run.
12. Feed the documents into the scanner.
13. Press Stop or End, depending on whether the batch or job has
been completed.
NOTE: After you press Stop, Run can be pressed again and more
documents can be fed into the scanner. After pressing End,
you must enable the scanner from the host computer before
scanning again.
Turning on the
scanner
Follow the steps below to turn on the power to the scanner.
1. Turn on the power switch (located at the rear of the machine).
NOTE: Several initialization messages will appear in the status
display. If you cannot see any messages, try adjusting the
contrast.
2. Send the Scan command from the host computer to the scanner.
The message
Enabled
will appear in the status display. The current
application mode and next image address will also be displayed.
IMPORTANT:
Do not use the operating keys until the Warming Up
Completed message has been displayed. Entries
made before this message is displayed will not be
recognized by the scanner.
- Document Scanner 5500 1
- Document Scanner 7500 1
- Kodak Digital 2
- Digital Science 3
- 1 Introduction 4
- Scanner options 5
- Scanner components 6
- For European units only: 7
- Control panel 8
- Operating keys and 9
- Operating keys and indicators 10
- Confirmation tone/alarm 10
- 2 Getting Started 11
- Selecting the 12
- Calibrating the 12
- Preparing 13
- Adjusting the feed 14
- A-61070 September 1999 2-5 15
- Adjusting the separator 16
- Adjusting the side 17
- Adjusting the exit 18
- A-61070 September 1999 2-9 19
- 3 Operating the Scanner 20
- Setting image levels 21
- Selecting a mode 21
- Temporary operating 22
- Feeding documents 23
- Feeding thick 25
- 4 Function Codes 27
- Function code 28
- A-61070 September 1999 4-3 29
- Function code listing 30
- A-61070 September 1999 4-5 31
- 4-6 A-61070 September 1999 32
- A-61070 September 1999 4-7 33
- 5 Maintenance 34
- Daily maintenance 35
- A-61070 September 1999 5-3 36
- 5-4 A-61070 September 1999 37
- Cleaning the feed and 38
- 5-6 A-61070 September 1999 39
- Cleaning the feeder 40
- 5-8 A-61070 September 1999 41
- Cleaning the paper path 42
- Weekly maintenance 43
- A-61070 September 1999 5-11 44
- 5-12 A-61070 September 1999 45
- Cleaning the cabinet 46
- Replacement 47
- A-61070 September 1999 5-15 48
- 5-16 A-61070 September 1999 49
- Replacing the imaging 50
- 5-18 A-61070 September 1999 51
- A-61070 September 1999 5-19 52
- Replacing the feeder 53
- A-61070 September 1999 5-21 54
- Ordering 55
- Ordering cleaning 55
- 6 Operator Messages 56
- Controlled power 57
- Operator message listing 58
- 7 Troubleshooting 65
- 7-2 A-61070 September 1999 66
- Clearing the 67
- Clearing documents 68
- The feeder area 69
- Horizontal transport 70
- A-61070 September 1999 7-7 71
- Vertical transport plate 72
- Red arrow 73
- Red rectangle 73
- Document exit and 74
- Removing non-jammed 74
- 8 Accessories 75
- Parts and tools 76
- Using the Bar Code Reader 77
- Bar code types 78
- Bar code placement 79
- Before you begin 79
- Enabling bar 80
- Enabling the bar 80
- Performing a bar 81
- Using the Evaluate 82
- A-61070 September 1999 8-9 83
- Maintenance 84
- A-61070 September 1999 8-11 85
- Please Wait 87
- Not Found 87
- Evaluating test results 88
- A-61070 September 1999 8-15 89
- Code Made Easy 90
- Using the Display 91
- BC Type = 92
- *XXXXXXXXXXXXX 92
- Using the Read Rate 93
- Using the Footswitch 94
- Footswitch 95
- Released actions 95
- Using the Patch Reader 96
- Patch code 97
- Printing patches 97
- Patch Reading 98
- Changing the 99
- Printed information 100
- Front and rear 101
- Document Printer 101
- Vertical start print 102
- Horizontal print 103
- IMPORTANT: 104
- Function codes 105
- Using the Print Test 105
- Cleaning the ink 106
- 8-34 A-61070 September 1999 107
- A-61070 September 1999 8-35 108
- 8-36 A-61070 September 1999 109
- A-61070 September 1999 8-37 110
- Replacing the ink 111
- A-61070 September 1999 8-39 112
- Replacing the rear 113
- Document Printer ink 113
- Appendix A Basic Concepts 114
- Image addresses 115
- Using Function Code F92 116
- Image address 117
- Indexing schemes 118
- Two level indexing 119
- Two level offset indexing 120
- Three level indexing 121
- Three level offset 122
- Controlling document 123
- header file. See the 123
- Checking the meters 124
- DOCUMENT 125
Verwandte Produkte und Handbücher für Multifunktionsgeräte Kodak Digital Science 5500
(2 Seiten)Panasonic CSE12LKEW manuali
Manuali dei proprietari e guide per l'utente per Lettori DVD Panasonic CSE12LKEW.
We fornisce manuali pdf Panasonic CSE12LKEW per scaricare gratuitamente in base al tipo di documento:
Kommentare zu diesen Handbüchern